Downrigger rail bracket

The rigging table allows you to install the deep rigging exactly where you want it. The product is made of UV-resistant plastic, and it is really sturdy.

Characteristics

• Can be installed on both sides of the boat
• It is easy to machine suitable mounting holes in the plastic
• Easy to attach and detach
• Can be attached to railings with a diameter of 25mm (universal size)
• The plastic part is made of PE plastic and the metal parts of 316L acid-resistant steel
• Suitable for all deep rigs with a mounting part less than 150*160mm (e.g. most Scotty & Cannon products)
• Dimensions (w*d*d) 150mm*180mm*25mm

Installation

1) Pre-tighten the fixing plate to the railing with two aluminum railing brackets.

2) Loosely fasten the 25mm aluminum staff of the support rod to the mounting plate.

3) Place the mounting plate horizontally, and measure the appropriate length of the support rod. The length is usually measured from the edge of the boat to the top.

4) Shorten the support rod with a hacksaw, for example, and install a rubber plug on the cut end. Note the rubber plug adds about 2mm to the length.

5) Attach and tighten the support rod to the mounting plate. The support bar should be installed at the back of the boat (in the picture, the rack on the right).

6) Finally, tighten both railing fasteners, and drill holes for rigging.